ASTM International

Standard Specification for Driven Fasteners: Nails, Spikes, and Staples
 N F1667

Annotation

This specification covers nails, spikes, staples, and other driven fasteners, as listed in Table 1

NOTE 1—Fastener ductility information is presented in Table 2 and dimensional information in Tables 3–65

Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and are positioned by hand, tool, or machine

The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard

Fasteners in this specification are sold in bulk (loose) form and are collated for loading into the magazine of an application tool. Other than as covered in Section 9, Workmanship, cohering materials (including, but not limited to, plastic, adhesive bond, paper tape, plastic strip, plastic carrier, wire, etc.) and relative orientation of collated fasteners are not within the scope of this standard

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee

*A Summary of Changes section appears at the end of this standard