DIN EN ISO 2692 Geometrical product specifications (GPS) - Geometrical tolerancing - Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR) (ISO 2692:2014)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN LN 9025 Aerospace - Washers
- 49
- DINGCD23
- DIN EN 14399-10 High-strength structural bolting assemblies for preloading - Part 10: System HRC - Bolt and nut assemblies with calibrated preload
- DIN EN 14399-5 High-strength structural bolting assemblies for preloading - Part 5: Plain washers
- DIN EN 14399-5 High-strength structural bolting assemblies for preloading - Part 5: Plain washers
- DIN EN 14399-1 High-strength structural bolting assemblies for preloading - Part 1: General requirements
- DIN EN ISO 4759-3 Tolerances for fasteners - Part 3: Plain washers for bolts, screws and nuts - Product grades A and C (ISO 4759-3:2000)
- ISO 1101 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out - Fourth Edition
- DIN EN ISO 4759-3 Tolerances for fasteners - Part 3: Washers for bolts, screws and nuts - Product grades A, C and F (ISO 4759-3:2016)
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Geometrical product specifications (GPS) - Geometrical tolerancing - Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR) (ISO 2692:2014)
N EN ISO 2692
Annotation
This International Standard defines the maximum material requirement, the least material requirement and the reciprocity requirement.
These requirements can only be applied to features of size. These requirements are used to control specific functions of workpieces where size and geometry are interdependent, e.g. to fulfil the functions “assembly of parts” (for maximum material requirement) or “minimum wall thickness” (for least material requirement). However, the maximum material requirement and least material requirement are also used to fulfil other functional design requirements.
Considering this interdependence between size and geometry, the principle of independency defined in ISO 8015 does not apply when the maximum material requirement, least material requirement, or reciprocity requirement, are used.
Автоматический перевод:
Геометрические технические характеристики изделия (GPS) - Геометрический tolerancing - Максимальное существенное требование (MMR), наименьшее количество существенного требования (LMR) и требование взаимности (RPR) (ISO 2692:2014)
Этот Международный стандарт определяет максимальное существенное требование, наименее существенное требование и требование взаимности.
