DIN EN ISO 17855-2 Plastics - Polyethylene (PE) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 17855-2:2016)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN EN 13121-3+A1 GRP tanks and vessels for use above ground - Part 3: Design and workmanship
- 23
- SNV SN EN 13121-3+A1 GRP tanks and vessels for use above ground - Part 3: Design and workmanship
- 23.020
- SNV SN EN 13121-3+A1 GRP tanks and vessels for use above ground - Part 3: Design and workmanship
- 23.020.10
- CEN EN 13121-3 GRP tanks and vessels for use above ground - Part 3: Design and workmanship - Incorporates Amendment A1: 2010; Incorporating corrigendum May 2011
- CEN EN 13121-3 GRP tanks and vessels for use above ground - Part 3: Design and workmanship - Incorporates Amendment A1: 2010; Incorporating corrigendum May 2011
- CEN EN 13121-2 GRP tanks and vessels for use above ground Part 2: Composite materials Chemical resistance
- BSI BS EN 13121-3 + A1 GRP tanks and vessels for use above ground - Part 3: Design and workmanship - AMD: August 31, 2010; CORR: October 31, 2011
- ISO 899-1 AMD 1 Plastics - Determination of creep behaviour - Part 1: Tensile creep AMENDMENT 1 - Second Edition
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Plastics - Polyethylene (PE) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 17855-2:2016)
N EN ISO 17855-2
Annotation
This International Standard specifies minimum thickness requirements for six classes of zinc diffusion layers applied to ferrous products by the sherardizing process for the purpose of protection against corrosion and wear.
This International Standard does not specify any requirements for the surface condition (finish or roughness) of the basis material before sherardizing.
Post-treatments (conversion coatings), after-treatments or organic over-coatings (Duplex) of sherardized articles are not in the scope of this International Standard.
NOTE 1 For general information about post-treatments, see Annex C and Annex D.
This International Standard does not apply to sherardized products (e.g. fasteners, tubes) for which specific standards exist and which might include additional requirements or requirements which are different from those of this International Standard.
NOTE 2 Individual product standards can incorporate this International Standard for the coating by quoting its number, or can incorporate it with modification specific to the product.
Автоматический перевод:
Пластмасса - Полиэтилен (PE) лепное украшение и материалы вытеснения - Часть 2: Подготовка испытательных образцов и определение свойств (17855-2:2016 ISO)
