ASTM International

Standard Test Method for Column Crush Properties of Blown Thermoplastic Containers
 N D2659

Annotation

This test method covers the determination of mechanical properties of blown thermoplastic containers, whether blown commercially or in the laboratory, loaded under columnar crush conditions at a constant rate of compressive deflection.

NOTE 1—Although this test method was developed specifically for blow-molded containers, the general procedure can also be applied to containers of suitable geometries produced by other means, for example, thermoforming, injection molding, etc.

1.2 The values stated in SI units are to be regarded as the standard.

NOTE 2—There is no known ISO equivalent to this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартный метод испытаний для свойств давки колонки унесенных термопластических контейнеров

Этот метод тестирования покрывает определение механических свойств унесенных термопластических контейнеров, унесенный ли коммерчески или в лаборатории, загруженной при колоночных условиях давки на постоянном уровне сжимающего отклонения.