Deutsches Institut fur Normung e. V.

Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 8: Porthole tubes, tolerances on dimensions and form
 N EN 754-8

Annotation

This European Standard specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube, see Figure 1) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube, see Figure 2), supplied in straight lengths.

This document only applies to cold drawn tube for general engineering applications made in the following alloys:

— EN AW-1050A, EN AW-1200;

— EN AW-3003, EN AW-3103;

— EN AW-5005, EN AW-5005A, EN AW-5049, EN AW-5251, EN AW-5052;

— EN AW-6012, EN AW-6060, EN AW-6061, EN AW-6262, EN AW-6262A;

— EN AW-6063, EN AW-6063A, EN AW-6065, EN AW-6082;

— EN AW-7020.

The temper designations used in this part are according to EN 515.

This document only applies to tube produced by the porthole/bridge method of extrusion only (and then cold drawn to the final dimensions).

This document does not apply to:

— cold drawn tubes produced by the seamless, die/mandrel method (EN 754-7),

— tubes delivered in coils (EN 13958),

— coiled tubes cut to length (EN 13958).