Solid State Technology Association

Resistance to Solder Shock for Through-Hole Mounted Devices
 N JESD22-B106E

Annotation

This test method is used to determine whether solid state devices can withstand the effect of the temperature shock to which they will be subjected during soldering of their leads in a solderwave process and/or solder fountain (rework/replacement) process. The heat is conducted through the leads into the device package from solder heat at the reverse side of the board.

This test method shall not be used to simulate wave soldering of surface mount device packages that are glued onto the same side of the board as the solder wave and are fully submerged into the solder wave. The test method for simulating SMT devices through the wave is JESD22-A111, Evaluation Procedure for Determining Capability to Bottom Side Board Attach by Full Body Solder Immersion of Small Surface Mount Solid State Devices.

In order to establish a standard test procedure for the most reproducible methods, the solder dip method is used because of its more controllable conditions. This procedure will determine whether devices are capable of withstanding the soldering temperature encountered in printed wiring board assembly operations, without degrading their electrical characteristics or internal connections. This test is destructive and may be used for qualification, lot acceptance and as a product monitor.

Автоматический перевод:

Сопротивление для запаивания шока для установленных устройств через отверстие

Этот метод испытаний используется, чтобы определить, могут ли полупроводниковые приборы противостоять эффекту температурного шока, которому они будут подвергнуты во время запаивания их, ведет в процессе solderwave, и/или фонтан припоя (переделывают/замена) процесс. Тепло проведено посредством приведения в пакет устройства от тепла припоя в обратной стороне правления.