AGA B109.4 Self-Operated Diaphragm-Type Natural Gas Service Regulators For Nominal Pipe Size 1? inches (32 mm) and smaller with outlet pressures of 2 psig (13.8 kPa) and less - XM1602
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- 23
- ASME B31E Standard for the Seismic Design and Retrofit of Above-Ground Piping Systems
- ASME B16.21 Nonmetallic Flat Gaskets for Pipe Flanges
- ASTM F363 Standard Test Method for Corrosion Testing of Gaskets
- ASTM F112 Standard Test Method for Sealability of Enveloped Gaskets
- ASTM F336 Standard Practice for Design and Construction of Nonmetallic Enveloped Gaskets for Corrosive Service
- ASME B16.3 Malleable Iron Threaded Fittings Classes 150 and 300
- Картотека зарубежных и международных стандартов
American Gas Association
Self-Operated Diaphragm-Type Natural Gas Service Regulators For Nominal Pipe Size 1? inches (32 mm) and smaller with outlet pressures of 2 psig (13.8 kPa) and less - XM1602
N B109.4
Annotation
This standard shall apply to the minimum design, material, performance and testing requirements of 1? inches (32 mm) and smaller self-operated diaphragm-type natural gas service regulators operating at inlet pressures up to 125 psig (861.8 kPa). These regulators are used to control the gas delivery pressure (also referred to as set pressure or P2) to pressures at 2 psig or less (13.8 kPa). This standard shal l apply only to regulators manufactured after the approval date of this standard.
Автоматический перевод:
Самоуправляемые сервисные Регуляторы Природного газа Типа Диафрагмы Для Номинального Размера Трубы 1 дюймы (32 мм) и меньший с давлениями выхода 2 фунтов на квадратный дюйм (13.8 кПа) и менее - XM1602
Этот стандарт должен относиться к минимальному дизайну, материалу, производительности и требованиям тестирования 1 дюймов (32 мм) и меньшим самоуправляемым сервисным регуляторам природного газа типа диафрагмы, работающим при входных давлениях до 125 фунтов на квадратный дюйм (861.8 кПа). Эти регуляторы используются для контролирования давления поставки газа (также называемый давлением набора или P2) к давлениям на уровне 2 фунтов на квадратный дюйм или меньше (13.8 кПа). Этот стандарт должен быть l применяться только к регуляторам, произведенным после даты утверждения этого стандарта.



