ASTM International

Standard Test Method for Failure in Sewn Seams of Woven Fabrics
 N D1683/D1683M

Annotation

This test method measures the sewn seam strength in woven fabrics by applying a force perpendicular to the sewn seams.

The axis perpendicular to the sewn seam can represent either the warp yarn axis or filling yarn axis, the same axis tested when using grab Test Method D5034.

This test method is applicable to sewn seams obtained from a previously sewn article or seams sewn with fabric samples using one of two specific seam assemblies as shown in Table 1.

This test method is used when the maximum breaking force measurement to rupture of a woven fabric sewn seam is required.

This test method is used when the seam efficiency measurement of a woven fabric sewn seam is required.

This test method is used to identify the sewn seam strength threshold at which the failure of the stitching occurs, without damage to the fabric, so that the textile product can be repaired.

This test method is used to identify the force at which seam strength results in slippage and displacement of warp yarns, filling yarns, or any combination of these yarns.

This test method does not predict actual wear performance of a seam.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.