CEI EN 60214-1 Tap-changers Part 1: Performance requirements and test methods
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- CSA CAN/CSA-C22.2 NO. 61010-031-07 Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use - Part 031: Safety requirements for hand-held probe assemblies for electrical measurement and test - First Edition
- 19
- CSA CAN/CSA-C22.2 NO. 61010-031-07 Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use - Part 031: Safety requirements for hand-held probe assemblies for electrical measurement and test - First Edition
- 19.080
- IEC 60529 CORR 3 Degrees of Protection Provided by Enclosures (IP Code) - Edition 2.1
- 13
- IEC 60529 CORR 3 Degrees of Protection Provided by Enclosures (IP Code) - Edition 2.1
- 13.260
- IEC 60529 CORR 3 Degrees of Protection Provided by Enclosures (IP Code) - Edition 2.1
- 29
- IEC 60529 CORR 3 Degrees of Protection Provided by Enclosures (IP Code) - Edition 2.1
- CSA CAN/CSA-C22.2 NO. 61010-031-07 AMD 1 Safety requirements for electrical equipment for measurement, control and laboratory use - Part 031: Safety requirements for hand-held probe assemblies for electrical measurement and test - First Edition
- Картотека зарубежных и международных стандартов
Comitato Elettrotecnico Italiano
Tap-changers Part 1: Performance requirements and test methods
N EN 60214-1
Annotation
This part of IEC 60214 applies to on-load tap-changers of both resistor and reactor types, deenergized tap-changers, and their motor-drive mechanisms.
It applies mainly to tap-changers immersed in mineral insulating oil according to IEC 60296 but may also be used for tap-changers with air or gas insulation or immersed in other insulating liquids insofar as conditions are applicable.
It applies mainly to tap-changers with arcing contacts but may also be used for arcing-free onload tap-changers (such as electronic switching) insofar as conditions are applicable.
This part of IEC 60214 applies to power and distribution transformers of all types and also to reactors.
It does not apply to transformers and reactors mounted on railway rolling stock.
Автоматический перевод:
Часть 1 преобразователей сигнала: Эксплуатационные требования и методы испытаний
Эта часть IEC 60214 относится к преобразователям касания на загрузке и резистора и реакторных типов, обесточенных преобразователей касания и их механизмов электропривода.
Это применяется в основном к преобразователям касания, погруженным в минеральную изоляционную нефть согласно IEC 60296, но может также использоваться для преобразователей касания с воздухом или газовой изоляцией или погружаться в другие изоляционные жидкости, поскольку условия применимы.
