JSA JIS B 1554 Rolling Bearings - Locknuts and locking devices
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- JSA JIS C 6950-1 Information technology equipment - Safety - Part 1: General requirements
- JSA JIS K 7350-2 Plastics - Methods of Exposure to Laboratory Light Sources - Part 2: Xenon-arc lamps
- JSA JIS K 7111-1 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
- 35
- JSA JIS C 6950-1 Information technology equipment - Safety - Part 1: General requirements
- JSA JIS K 7350-2 Plastics - Methods of Exposure to Laboratory Light Sources - Part 2: Xenon-arc lamps
- JSA JIS K 7111-1 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
- 35.020
- 35.260
- JSA JIS C 6950-1 Information technology equipment - Safety - Part 1: General requirements
- JSA JIS K 7111-1 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
- JSA JIS K 6718-3 Plastics - Poly(methyl methacrylate) sheets - Types, dimensions and characteristics - Part 3: Continuous cast sheets
- JSA JIS K 7350-2 Plastics - Methods of Exposure to Laboratory Light Sources - Part 2: Xenon-arc lamps
- JSA JIS A 5741 Wood-plastic recycled composite
- JSA JIS A 5742 Products of wood-plastic recycled composite - Assembled decks
- JSA JIS G 3101 Rolled steels for general structure
- JSA JIS C 6950-1 Information technology equipment - Safety - Part 1: General requirements
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Rolling Bearings - Locknuts and locking devices
N JIS B 1554
Annotation
This Standard specifies locknut for rolling bearing (hereafter referred to as "locknut"), lockwasher for rolling bearing (hereafter referred to as "lockwasher") and locking clip for rolling bearing (hereafter referred to as "locking clip"), to be used mainly for adapter sleeve and withdrawal sleeve for rolling bearing specified in JIS B 1552.
- The locknuts are used for locating adapter sleeves, withdrawal sleeves, and bearing inner rings on shafts.
- The lockwashers are used with 4-slot locknuts.
NOTE 1 Lockwashers are classified into those with straight inner tab, and those with bent inner tab (see Annex A).
- The locking clips are used with 8-slot locknuts.
NOTE 2 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 2982-2 : 2013 Rolling bearings - Accessories - Part 2 : Dimensions for locknuts and locking devices (MOD)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Роликовые подшипники - Стопорные гайки и устройства захвата
