DIN EN ISO 14120 Safety of machinery - Guards - General requirements for the design and construction of fixed and movable guards (ISO 14120:2015)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- IEC 60947-5-5 Low-voltage switchgear and controlgear – Part 5-5: Control circuit devices and switching elements – Electrical emergency stop device with mechanical latching function - Edition 1.1 Consolidated Reprint
- 29
- IEC 60947-5-5 Low-voltage switchgear and controlgear – Part 5-5: Control circuit devices and switching elements – Electrical emergency stop device with mechanical latching function - Edition 1.1 Consolidated Reprint
- 29.120
- IEC 60947-5-5 Low-voltage switchgear and controlgear – Part 5-5: Control circuit devices and switching elements – Electrical emergency stop device with mechanical latching function - Edition 1.1 Consolidated Reprint
- 29.120.99
- 29.130
- IEC 60947-5-5 Low-voltage switchgear and controlgear – Part 5-5: Control circuit devices and switching elements – Electrical emergency stop device with mechanical latching function - Edition 1.1 Consolidated Reprint
- 29.130.20
- IEC 60204-1 Safety of machinery – Electrical equipment of machines – Part 1: General requirements - Edition 5.1 Consolidated Reprint
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Safety of machinery - Guards - General requirements for the design and construction of fixed and movable guards (ISO 14120:2015)
N EN ISO 14120
Annotation
This International Standard specifies general requirements for the design, construction, and selection of guards provided to protect persons from mechanical hazards. This International Standard indicates other hazards that can influence the design and construction of guards.
This International Standard applies to guards for machinery which will be manufactured after it is published.
The requirements are applicable if fixed and movable guards are used. This International Standard does not cover interlocking devices. These are covered in ISO 14119.
This International Standard does not provide requirements for special systems relating specifically to mobility such as ROPS (rollover protective structures), FOPS (falling-object protective structures), and TOPS (tip over protective structures) or to the ability of machinery to lift loads.
Автоматический перевод:
Безопасность машинного оборудования - гвардии - Общие требования для проектирования и строительства фиксированных и съемных кожухов (ISO 14120:2015)
Этот Международный стандарт определяет общие требования для дизайна, строительства и выбора охранников, предоставленных для защиты людей от механических опасностей. Этот Международный стандарт указывает на другие опасности, которые могут влиять на проектирование и строительство охранников.
