ASTM International

Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes
 N A450/A450M

Annotation

This specification2 covers a group of requirements which, with the exceptions of 5.3 and Sections 6, 7, 18, 19, 20, 21, 22, 23, and 24, are mandatory requirements to the following ASTM tubular product specifications:3

One or more of Sections 5.3, 6, 7, 18, 19, 20, 21, 21.1, 23, and 24 apply when the product specification or purchase order has a requirement for the test or analysis described by these sections.

In case of conflict between a requirement of the product specification and a requirement of this general requirement specification only the requirement of the product specification need be satisfied.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the "M" designation (SI) of the product specification is specified in the order.

2 For ASME Boiler and Pressure Vessel Code applications see related Specification SA-450 in Section II of that Code.

3 Annual Book of ASTM Standards, Vols 01.01 and 01.04.

*A Summary of Changes section appears at the end of this standard.

Автоматический перевод: