ASTM International

Standard Specification for Molds for Forming Concrete Test Cylinders Vertically
 N C470/C470M

Annotation

This specification covers molds for use in forming cylindrical concrete specimens. The provisions of this specification include the requirements for both reusable and singleuse molds.

NOTE 1—Sizes included are molds having diameters from 50 mm [2 in.] to 900 mm [36 in.].

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units are shown in brackets.

The following safety hazards caveat pertains only to the test method described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

*A Summary of Changes section appears at the end of this standard.

Автоматический перевод:

Стандартная спецификация для форм для формирования бетона тестирует цилиндры вертикально