ASTM International

Standard Test Method for Boron in Water
 N D3082

Annotation

This test method covers the determination of boron in water and wastewaters by the curcumin colorimetric-extraction method2 in concentrations between 0.1 and 1.0 mg/L. The range can be extended by dilution of the sample.

Only dissolved boron is determined. This test method requires that the water sample be filtered through a 0.45-?m membrane filter before analysis.

This test method is a colorimetric method that is very sensitive to low concentrations of boron in water and requires a relatively small sample volume for analysis.

Precision and bias were obtained on natural and wastewaters. It is the user’s responsibility to ensure the validity of this test method for waters of untested matrices.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартный метод тестирования для бора в воде

Этот метод тестирования покрывает определение бора в воде и сточных водах колориметрической экстракцией куркумина method2 в концентрациях между 0.1 и 1.0 mg/L. Диапазон может быть расширен разводнением образца.