ASTM International

Standard Test Method for Flexural Rigidity of Geogrids, Geotextiles and Related Products
 N D7748/D7748M

Annotation

This test method covers the measurement of stiffness properties of geogrids, geotextiles and geogrid-geotextile composites all of which are referred to as geosynthetics within this test method. Bending length is measured and flexural rigidity is calculated through use of the cantilever test procedure.

This test method employs the principle of cantilever bending of the geosynthetic under its own mass.

This test method applies to geogrids, geotextiles and geogrid-geotextile composites.

This test method is for manufacturing quality control purposes only, to ensure uniformity and consistency of flexural rigidity for a specific product from roll to roll and lot to lot.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Автоматический перевод:

Метод стандартной пробы для жесткости при изгибе Geogrids, Geotextiles и Related Products