ASTM International

Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory
 N C192/C192M

Annotation

This practice covers procedures for making and curing test specimens of concrete in the laboratory under accurate control of materials and test conditions using concrete that can be consolidated by rodding or vibration as described herein.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to exposed skin and tissue upon prolonged exposure.2)

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Утвержденный технологический процесс для того, чтобы сделать и вылечить конкретные испытательные образцы в лаборатории

Эта практика покрывает процедуры для того, чтобы сделать и вылечить испытательные экземпляры бетона в лаборатории под точным контролем материалов и условий испытания с помощью бетона, который может быть консолидирован rodding или вибрацией, как описано в настоящем документе.