ASTM F468M Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040
- API SPEC 20E Alloy and Carbon Steel Bolting for Use in the Petroleum and Natural Gas Industries - FIRST EDITION; ERTA: October 2014
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
N F468M
Annotation
This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.
Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.
The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
NOTE 1—This specification is the metric companion of Specification F468.
*A Summary of Changes section appears at the end of this standard.
Автоматический перевод:
Стандартная спецификация для цветных болтов, шестнадцатеричных винтов с головкой и гвоздиков для общего использования (метрика)
Эта спецификация удовлетворяет требования для коммерческих выделанных цветных болтов, шестнадцатеричных винтов с головкой и контактов в номинальных диаметрах резьбы M6 к M36, включительно произведенному от многих сплавов, широко использующихся и предназначенных для приложений общих служб.
