ASTM A971/A971M Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM A1054 Standard Specification for Sintered Ceramic Ferrite Permanent Magnets
- 29
- ASTM A1054 Standard Specification for Sintered Ceramic Ferrite Permanent Magnets
- 29.030
- ASTM A1009 Standard Specification for Soft Magnetic MnZn Ferrite Core Materials for High Frequency (10 kHz-1 MHz) Power Transformer and Filter Inductor Applications
- 29.100
- ASTM A1009 Standard Specification for Soft Magnetic MnZn Ferrite Core Materials for High Frequency (10 kHz-1 MHz) Power Transformer and Filter Inductor Applications
- ASTM A1009 Standard Specification for Soft Magnetic MnZn Ferrite Core Materials for High Frequency (10 kHz-1 MHz) Power Transformer and Filter Inductor Applications
- ASTM A1013 Standard Test Method for High-Frequency (10 KHz-1 MHz) Core Loss of Soft Magnetic Core Components at Controlled Temperatures Using the Voltmeter-Ammeter-Wattmeter Method
- ASTM A34/A34M Standard Practice for Sampling and Procurement Testing of Magnetic Materials
- ASTM A977/A977M Standard Test Method for Magnetic Properties of High-Coercivity Permanent Magnet Materials Using Hysteresigraphs
- ASTM A340 Standard Terminology of Symbols and Definitions Relating to Magnetic Testing
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Measuring Edge Taper and Crown of Flat-Rolled Electrical Steel Coils
N A971/A971M
Annotation
This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill.
The values and equations stated in customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within this standard, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this standard.
The following material specifications include requirements for edge taper or crown: A677, A683, A726, A840, and A876.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Метод стандартной пробы для измерения тонкой свечи края и короны кативших квартирой катушек электрической стали
Этот метод тестирования предоставляет процедуру для измерения граничного заострения и короны плоско прокрученных обмоток электрической стали, как произведено в сталелитейном заводе.
