ASTM International

Standard Guide to Obtainable  Equivalent Penetrameter Sensitivity for Radiography of Steel Plates 1?4 to 2 in. (6 to 51 mm) Thick with X-Rays and 1 to 6 in. (25 to 152 mm) Thick with Cobalt-60
 N E592

Annotation

This guide to obtainable equivalent penetrameter sensitivity covers the minimum penetrameter thicknesses for which the image of the 1T and 2T holes is visible for a few practical radiographic conditions. The values represent near optimum sensitivity for flat steel plates. Radiographic conditions that give higher values of scatter buildup from the specimen or backscattered radiation at the image plane will give poorer sensitivity.

Eight radiographs that illustrate sensitivities obtainable with practical radiographic systems are included as adjuncts to this guide and may be obtained from ASTM.

The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартный Справочник по Доступному ASTM Эквивалентная Чувствительность Penetrameter для Рентгена Стальных плит 1 4 к 2 дюймам. (6-51миллиметровая) Гуща с Рентгеновскими лучами и 1 - 6 дюймов. (25-152миллиметровая) Гуща с Кобальтом 60