ASTM F2882M Standard Specification for Screws, Alloy Steel, Heat Treated, 1170 MPa Minimum Tensile Strength [Metric]
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13.040
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13.040.30
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- ULC CAN/ULC-S560-06 STANDARD FOR CATEGORY 3 AQUEOUS FILM-FORMING FOAM (AFFF) LIQUID CONCENTRATES - Second Edition
- ASTM B995 REV A Standard Test Method for Chloride Resistance Test for Chromium Electroplated Parts (Russian Mud Test)
- ASTM B117 Standard Practice for Operating Salt Spray (Fog) Apparatus
- ASTM F2832 Standard Guide for Accelerated Corrosion Testing for Mechanical Fasteners
- ASME B18.12 Glossary of Terms for Mechanical Fasteners
- ASME B18.30.1M Open-End Blind Rivets with Break Mandrels (Metric Series)
- ASME B18.3.1M Socket Head Cap Screws (Metric Series)
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Screws, Alloy Steel, Heat Treated, 1170 MPa Minimum Tensile Strength [Metric]
N F2882M
Annotation
This specification covers the requirements for quenched and tempered alloy steel screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1170 MPa.
NOTE 1-This specification is the metric companion of Specification F2882.
The following hazard caveat pertains only to the test method portion, Section 10, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартная спецификация для винтов, легированной стали, термически обработанного, минимального предела прочности на 1170 МПа [метрика]
Эта спецификация удовлетворяет требования для подавленных и умеренных винтов легированной стали 1.6 мм через 48 мм в диаметре, имеющем минимальный окончательный предел прочности 1170 МПа.
Note-1-эта спецификация является метрическим компаньоном Спецификации F2882.
