ASTM F2657 Standard Test Method for Outdoor Weathering Exposure of Crosslinked Polyethylene (PEX) Tubing
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN ISO 161-1 Thermoplastics pipes for the conveyance of fluids - Nominal outside diameters and nominal pressures - Part 1: Metric series
- 23
- SNV SN ISO 161-1 Thermoplastics pipes for the conveyance of fluids - Nominal outside diameters and nominal pressures - Part 1: Metric series
- 23.040
- ISO 12500-1 Filters for compressed air — Test methods — Part 1: Oil aerosols - First Edition
- ISO 5782-2 Pneumatic Fluid Power - Compressed Air Filters - Part 2: Test Methods to determine the Main Characteristics to Be Included in Supplier?s Literature - First Edition
- BSI BS ISO 5782-1 Pneumatic Fluid Power - Compressed Air Filters - Part 1: Main Characteristics to be Included in Supplier's Literature and Product-Marking Requirements
- ISO 5782-2 Pneumatic Fluid Power - Compressed Air Filters - Part 2: Test Methods to determine the Main Characteristics to Be Included in Supplier?s Literature - First Edition
- ISO 5782-2 Pneumatic Fluid Power - Compressed Air Filters - Part 2: Test Methods to determine the Main Characteristics to Be Included in Supplier?s Literature - First Edition
- BSI BS ISO 5782-1 Pneumatic Fluid Power - Compressed Air Filters - Part 1: Main Characteristics to be Included in Supplier's Literature and Product-Marking Requirements
- BSI BS ISO 5782-1 Pneumatic Fluid Power - Compressed Air Filters - Part 1: Main Characteristics to be Included in Supplier's Literature and Product-Marking Requirements
- ISO 2944 Fluid Power Systems and Components - Nominal Pressures - Second Edition
- SNV SN ISO 4065 Thermoplastic pipes - Universal wall thickness table
- ISO 161-2 Thermoplastics Pipes for the Conveyance of Fluids - Nominal Outside Diameters and Nominal Pressures - Part 2: Inch-Based Series - Second Edition
- ASTM F876 REV A Standard Specification for Crosslinked Polyethylene (PEX) Tubing
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Outdoor Weathering Exposure of Crosslinked Polyethylene (PEX) Tubing
N F2657
Annotation
This test method describes the procedure for exposing crosslinked polyethylene (PEX) tubing produced in accordance with Specification F876 to natural (sunlight) ultraviolet (UV) radiation and evaluating the effects of the exposure. This test method outlines the requirements for specimen size and preparation, exposure orientation, minimum UV exposure energy, post exposure testing and reporting.
NOTE 1—While other laboratory UV exposure systems are available, this test method relies on natural sunlight as the UV radiation source. Laboratory methods may be added in the future if testing confirms a correlation between natural sunlight and laboratory exposure.
PEX tubing is not designed for outdoor use. Data from short-term exposure testing per this test method can be used to judge the relative performance of PEX tubing stored outdoors for short periods of time prior to installation completely shielded from sunlight.
The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
The following precautionary caveat pertains only to the test method and post exposure testing portions, Sections 8 and 9 of this test method.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
