ASTM D6096 Standard Specification for Poly(Vinyl Chloride) Insulation for Wire and Cable, 90°C Operation
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- UL 444 UL Standard for Safety Communications Cables - Fourth Edition; Reprint with Revisions Through and Including April 30, 2015
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29.220
- 33
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 33.120
- 35
- ASTM D4565 Standard Test Methods for Physical and Environmental Performance Properties of Insulations and Jackets for Telecommunications Wire and Cable
- ASTM D2633 REV A Standard Test Methods for Thermoplastic Insulations and Jackets for Wire and Cable
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Poly(Vinyl Chloride) Insulation for Wire and Cable, 90°C Operation
N D6096
Annotation
This specification covers a thermoplastic insulation of poly (vinyl chloride) or the copolymer of vinyl chloride and vinyl acetate. This insulation is recommended for use at conductor temperatures not in excess of 90°C.
Depending on the thickness of the insulation, the maximum voltage used, and whether the location is wet or dry, this insulation is acceptable for use in 300 V (dry) and 600 V (wet or dry) power and control circuits.
This insulation has potential low-temperature installation limitations. Consult the manufacturer for specific recommendations for installation.
In many instances, the insulation material cannot be tested unless it has been formed around a conductor or cable. Therefore, tests are done on insulated wire or cable in this specification solely to determine the relevant property of the insulation material and not to test the conductor or completed cable.
The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
In some cases (including the title), temperatures are described in degrees Celsius only.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
Стандартная спецификация для Poly (виниловый хлорид) изоляция для провода и кабеля, 90°C эксплуатация
