JSA JIS P 8220-2 Pulps - Laboratory wet disintegration - Part 2: Disintegration of mechanical pulps at 20 degree C
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- JSA JIS P 8226 Pulps - Determination of fibre length by automated optical analysis - Part 1: Polarized light method
- 85
- JSA JIS P 8226 Pulps - Determination of fibre length by automated optical analysis - Part 1: Polarized light method
- 85.040
- JSA JIS P 8226 Pulps - Determination of fibre length by automated optical analysis - Part 1: Polarized light method
- JSA JIS P 8222 Pulps - Preparation of laboratory sheets for physical testing
- JSA JIS P 8222 Pulps - Preparation of laboratory sheets for physical testing
- JSA JIS P 8222 Pulps - Preparation of laboratory sheets for physical testing
- JSA JIS P 8230 Recycled pulps - Estimation of visible contraries by instrumental means using reflected light
- JSA JIS P 8203 Paper, board and pulps - Determination of dry matter content - Oven-drying method
- JSA JIS P 8220-2 Pulps - Laboratory wet disintegration - Part 2: Disintegration of mechanical pulps at 20 degree C
- JSA JIS P 8225 Pulps - Determination of stock concentration
- JSA JIS P 8220-1 Pulps - Laboratory wet disintegration - Part 1: Disintegration of chemical pulps
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Pulps - Laboratory wet disintegration - Part 2: Disintegration of mechanical pulps at 20 degree C
N JIS P 8220-2
Annotation
This Standard specifies an apparatus and the procedures for the disintegration of mechanical pulps that do not exhibit latency or mechanical pulps where latency has already been removed. This apparatus and procedure are required for preparation of the test portion in a number of other standards dealing with pulps.
In principle, this method is applicable to all kinds of mechanical pulps that do not exhibit latency, semi-chemical pulps and chemi-mechanical pulps, including recovered fibres from mechanical pulps. It is not suitable for mechanical pulps exhibiting latency.
This Standard should also be used to disintegrate all mechanical pulps to be measured for brightness.
NOTE 1 Brightness is not significantly altered by the presence of latency; however, hot disintegration of mechanical pulps can lead to significant loss of brightness .
NOTE 2 For the mechanical pulp exhibiting latency, the disintegration specified in ISO 5263-3 shall be used.
NOTE 3 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 5263-2 : 2004 Pulps - Laboratory wet disintegration - Part 2 : Disintegration of mechanical pulps at 20 °C(MOD)
The symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
