ASTM International

Standard Specification for Polyethylene Films Made from Low-Density Polyethylene for General Use and Packaging Applications
 N D4635 REV A

Annotation

This specification covers unpigmented, unsupported, low-density polyethylene films (hereafter referred to as film or films) from Class 1 polyethylenes per Specification D 4976.

NOTE 1—The density of a film will not necessarily be equal to the density of a molded plaque from the same resin.

NOTE 2—Blends of ethylene/vinylacetate (EVA) with low-density polyethylene may have densities up to 0.929 g/cm3.

This specification is applicable to homopolymer polyethylene, but is not restricted to it. It is applicable to films made from polyethylene copolymers, and also applicable to films made from blends of homopolymers and copolymers, including ethylene/vinylacetate copolymers.

The thickness of the films covered by this specification is 100 ?m or less (0.004 in. or less), inclusive. The maximum width of the sheet or layflat is 3.00 m (120 in.).

This specification does not cover oriented heatshrinkable films.

This specification allows for the use of recycled polyethylene film or resin as feedstock, in whole or in part, as long as all of the requirements of this specification are met and as long as any specific requirements as governed by the producer and end user are also met. (See Note 3.)

NOTE 3—Guide D 7209 describes terminology and definitions related to recycled plastics.

This specification defines the levels of the various physical properties from which specifications for specific films may be described. The levels of physical properties required by a film for a given application are selected from Section 6. However, Sections 2-5 relating to tolerances shall apply without change to all film falling within the scope indicated by the title and 1.1-1.4.