JSA JIS K 6259-1 Rubber, vulcanized or thermoplastic - Determination of ozone resistance - Part 1: Static and dynamic strain testing
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040.60
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.100
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- ISO 6162-1 Hydraulic fluid power - Flange connections with split or one-piece flange clamps and metric or inch screws - Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 - Second Edition
- JSA JIS B 8363 End fittings and adapters for hydraulic hose assemblies
- JSA JIS B 2401-1 O-rings - Part 1: O-rings
- JSA JIS K 6251 Rubber, vulcanized or thermoplastics - Determination of tensile stress-strain properties
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Rubber, vulcanized or thermoplastic - Determination of ozone resistance - Part 1: Static and dynamic strain testing
N JIS K 6259-1
Annotation
This Standard specifies the test method for the determination of the ozone resistance of vulcanized or thermoplastic rubber under static and dynamic strain testing.
NOTE: The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 1431-1: 2012 Rubber, vulcanized or thermoplastic-Resistance to ozone cracking-Part 1: Static and dynamic strain testing (MOD)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/ lEC Guide 21-1.
WARNING Persons using this Standard should be familiar with normallaboratory practice. This Standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this Standard to establish appropriate safety and health practices.
Автоматический перевод:
Резина, вулканизировавшая или термопласт - Определение озоностойкости - Часть 1: Статическое и динамическое испытание напряжения
Этот Стандарт определяет метод испытаний для определения озоностойкости вулканизировавших или термопластичной резины при статическом и динамическом испытании напряжения.
