ASTM International

Standard Test Method for Thermal Conductivity of Plastics by Means of a Transient Line-Source Technique
 N D5930

Annotation

This test method covers the determination of the thermal conductivity of plastics over a temperature range from – 40 to 400°C. The thermal conductivity of materials in the range from 0.08 to 2.0 W/m.K can be measured covering thermoplastics, thermosets, and rubbers, filled and reinforced.

The values stated in SI units shall be regarded as standard.

This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish proper safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—There is no known ISO equivalent to this test method.

*A Summary of Changes section appears at the end of this standard.

Автоматический перевод:

Стандартный метод испытаний для теплопроводности пластмассы посредством переходного метода источника линии

Этот метод тестирования покрывает определение теплопроводности пластмасс по диапазону температур от – 40 к 400°C. Теплопроводность материалов в диапазоне от 0.08 до 2.0 Вт/м. K может быть измерен, покрыв термопласты, термореактивные материалы, и резиновые изделия, заполнил и укрепил.