DIN EN ISO 4892-1 Plastics - Methods of exposure to laboratory light sources - Part 1: General guidance (ISO 4892-1:1999)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN EN 1279-6 Glass in building - Insulating glass units - Part 6: Factory production control and periodic tests
- 81
- DIN EN 1279-6 Glass in building - Insulating glass units - Part 6: Factory production control and periodic tests
- 81.040
- DIN EN 1279-6 Glass in building - Insulating glass units - Part 6: Factory production control and periodic tests
- 81.040.20
- CEN EN 14321-1 Glass in building - Thermally toughened alkaline earth silicate safety glass - Part 1: Definition and description
- DIN EN 15755-1 Glass in building - Adhesive backed polymeric filmed glass - Part 1: Definitions and requirements
- DIN EN 15755-1 Glass in building - Adhesive backed polymeric filmed glass - Part 1: Definitions and requirements
- DIN EN 572-2 Glass in building - Basic soda lime silicate glass products - Part 2: Float glass
- DIN EN 13022-1 Glass in building - Structural sealant glazing - Part 1: Glass products for structural sealant glazing systems for supported and unsupported monolithic and multiple glazing
- DIN EN 572-5 Glass in building - Basic soda lime silicate glass products - Part 5: Patterned glass
- DIN EN 15752-1 Glass in building - Adhesive backed polymeric film - Part 1: Definitions and requirements
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Plastics - Methods of exposure to laboratory light sources - Part 1: General guidance (ISO 4892-1:1999)
N EN ISO 4892-1
Annotation
This part of ISO 4892 provides information and general guidance relevant to the selection and operation of the methods of exposure described in detail in subsequent parts. It also describes and recommends procedures for determining irradiance and radiant exposure. Requirements for devices used to monitor chamber air temperature and surface temperature of dark and light materials are also described.
This part of ISO 4892 also provides information on the interpretation of data from accelerated exposure tests. More specific information about methods for determining the change in plastic properties after exposure and reporting these results is described in ISO 4852.
Автоматический перевод:
Пластмасса - Методы выставки к лабораторным источникам света - Часть 1: Общее руководство (4892-1:1999 ISO)
Эта часть ISO 4892 предоставляет информацию и общее руководство, относящееся к выбору и операции методов выставки, описанной подробно в последующих частях. Это также описывает и рекомендует процедуры для определения сияния и сияющей выставки. Требования для устройств раньше контролировали камерную температуру воздуха, и температура поверхности темных и легких материалов также описаны.
