DIN EN 16602-70-13 Space product assurance - Measurements of the peel and pull-off strength of coatings and finishes using pressure-sensitive tapes
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- CEN EN 16602-70-29 Space product assurance - Determination of offgassing products from materials and assembled articles to be used in a manned space vehicle crew compartment
- 49
- CEN EN 16602-70-29 Space product assurance - Determination of offgassing products from materials and assembled articles to be used in a manned space vehicle crew compartment
- 49.140
- CEN EN 16602-70-29 Space product assurance - Determination of offgassing products from materials and assembled articles to be used in a manned space vehicle crew compartment
- DIN EN 16602-20-07 Space produce assurance - Quality and safety assurance for space test centres
- DIN EN 16602-20-07 Space produce assurance - Quality and safety assurance for space test centres
- DIN EN 16602-20-07 Space produce assurance - Quality and safety assurance for space test centres
- DIN EN 16602-20-08 Space product assurance - Storage, handling and transportation of spacecraft hardware
- DIN EN 16602-70 Space product assurance - Materials, mechanical parts and processes
- DIN EN 16602-70-71 Space product assurance - Materials, processes and their data selection
- DIN EN 16602-70-10 Space product assurance - Qualification of printed circuit boards
- CEN EN 16602-20 Space product assurance - Quality assurance
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Space product assurance - Measurements of the peel and pull-off strength of coatings and finishes using pressure-sensitive tapes
N EN 16602-70-13
Annotation
This Standard details a test in which pressuresensitive tapes are used to assess the suitability of, for example, coatings, paints, films and other thin materials, proposed for use on spacecraft and associated equipment.
Surface coatings, such as thermal control paints and corrosion protection coatings, are affected, both on the ground and after launch, by exposure to the environment.
It is therefore important that the adhesion of the coating to the relevant substrate remains at an acceptable level after exposure to the relevant environmental condition.
The following materials and assemblies are covered by this test method:
- organic coating, e.g. varnishes, paints and plastic films;
- metallic finishes on, for example, printed circuit boards, secondsurface mirrors, thermal radiators, plastic films;
- adhesive layers;
- composite thin films;
- small assemblies, e.g. solar cells having attached glass covers.
This standard may be tailored for the specific characteristics and constrains of a space project in conformance with ECSS-S-ST-00.
Автоматический перевод:
