ASTM D5193/D5193M Standard Test Method for Coated Fabrics-Air Retention
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F1359/F1359M Standard Test Method for Liquid Penetration Resistance of Protective Clothing or Protective Ensembles Under a Shower Spray While on a Mannequin
- 13
- ASTM F1359/F1359M Standard Test Method for Liquid Penetration Resistance of Protective Clothing or Protective Ensembles Under a Shower Spray While on a Mannequin
- 13.340
- ASTM F1359/F1359M Standard Test Method for Liquid Penetration Resistance of Protective Clothing or Protective Ensembles Under a Shower Spray While on a Mannequin
- 13.340.10
- ASTM F1296 Standard Guide for Evaluating Chemical Protective Clothing
- ASTM F1383 Standard Test Method for Permeation of Liquids and Gases through Protective Clothing Materials under Conditions of Intermittent Contact
- ASTM D751 Standard Test Methods for Coated Fabrics
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Coated Fabrics-Air Retention
N D5193/D5193M
Annotation
This test method describes the determination of the retention of air by fabrics coated on one or both sides with rubber.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартный метод испытаний для задержания воздуха тканей с покрытием
Этот метод испытаний описывает определение задержания воздуха тканями, покрытыми на одной или обоих боках с резиной.
Значения, заявленные или в единицах СИ или в единицах дюйма-фунта, должны рассматриваться отдельно как стандарт. Значения, заявленные в каждой системе, могут не быть точными эквивалентами; поэтому, каждая система должна использоваться независимо от другого. Объединение значений от этих двух систем может привести к несоответствию со стандартом.



