JSA JIS M 8718 Iron ore pellets - Determination of crushing strength
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- JSA JIS Z 8823-2 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 2: Photocentrifuge method
- 19
- JSA JIS Z 8823-2 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 2: Photocentrifuge method
- 19.120
- JSA JIS Z 8823-2 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 2: Photocentrifuge method
- JSA JIS Z 8823-1 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 1: General principles and guidelines
- JSA JIS Z 8823-1 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 1: General principles and guidelines
- JSA JIS Z 8823-1 Determination of particle size distribution by centrifugal liquid sedimentation methods - Part 1: General principles and guidelines
- JSA JIS Z 8819-1 Representation of results of particle size analysis - Part 1: Graphical representation
- JSA JIS Z 8801-2 Test Sieves - Part 2: Test Sieves of Perforated Metal Plate
- JSA JIS M 8702 Iron ores-Sampling and sample preparation procedures
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Iron ore pellets - Determination of crushing strength
N JIS M 8718
Annotation
This Standard specifies a method to provide a measure of the compressive load attained to cause breakage of pellets for blast furnace (hereafeter referred to as "pellets").
This Standard is applicable to hot-bonded pellets.
NOTE 1 The corresponding International Standard, ISO 4700, is applicable to pellets for blast furnace and direct reduction feedstocks.
NOTE 2 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows :
ISO 4700 : 2007 Iron are pellets for blast furnace and direct reduction feedstocks -Determination of the crushing strength (MOD)
The symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Железорудные окатыши - Определение сокрушительной силы
Этот Стандарт определяет метод для обеспечения меры сжимающей загрузки, достигнутой к поломке причины шариков для доменной печи (hereafeter называемый "шариками").
