ISO 4250-3 Earth-mover tyres and rims — Part 3: Rims - Fourth Edition
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN CEN/TS 15730 Earth-moving machinery - Guidelines for assessment of exposure to whole-body vibration of ride-on machines - Use of harmonized data measured by international institutes, organizations and manufacturers (ISO/TR 25398:2006)
- 13
- DIN CEN/TS 15730 Earth-moving machinery - Guidelines for assessment of exposure to whole-body vibration of ride-on machines - Use of harmonized data measured by international institutes, organizations and manufacturers (ISO/TR 25398:2006)
- 13.160
- 53
- DIN CEN/TS 15730 Earth-moving machinery - Guidelines for assessment of exposure to whole-body vibration of ride-on machines - Use of harmonized data measured by international institutes, organizations and manufacturers (ISO/TR 25398:2006)
- 53.100
- SNV SN EN 1983 Industrial valves - Steel ball valves
- CEN EN 13445-3 Unfired pressure vessels - Part 3: Design - Incorporates Amendment A2: 2016
- CEN EN 286-2 Simple Unfired Pressure Vessels Designated to Contain Air or Nitrogen - Part 2: Pressure Vessels for Air Braking and Auxiliary Systems for Motor Vehicles and Their Trailers
- DIN EN 474-1 Earth-moving machinery - Safety - Part 1: General requirements
- Картотека зарубежных и международных стандартов
International Organization for Standardization
Earth-mover tyres and rims — Part 3: Rims - Fourth Edition
N 4250-3
Annotation
This part of ISO 4250 sets out the designation, contours and dimensions for rims for narrow- and wide-base off-road tyres primarily intended for earth-moving machinery.
All dimensions in this part of ISO 4250 are given in millimetres and are applicable to the side of the rim which is in contact with the tyre.
Tyre designations and dimensions, tyre classifications and nomenclature are given in ISO 4250-1, ISO 10571 and ISO 13442.
Annex A gives details on sealing ring grooves and O-rings for earth-mover rims.
Автоматический перевод:
Шины землеройной машины и оправы — Часть 3: Оправы - Четвертый Выпуск
Эта часть ISO 4250 излагает обозначение, контуры и измерения для оправ для узкого - и широко-основные шины для бездорожья, прежде всего предназначенные для землеройного машинного оборудования.
Все измерения в этой части ISO 4250 даны в миллиметрах и применимы к стороне оправы, которая находится в контакте с шиной.
