ASTM International

Standard Practice for Formatting Cutting Data to Drive Numerically Controlled Fabric Cutting Machines
 N D6672

Annotation

This practice specifies a data format for numericallycontrolled cutting machines for fabric.

This standard uses a subset of the defined instruction set defined in ANSI/EIA-274-D in addition to the codes defined by this practice.

This practice does not support curve interpolation or definitions. All curves are represented by discrete vectors (stroked) and are dependent on the resolution of the CAD software.

This practice requires that all coordinates are absolute, not relative.

This practice only supports positive coordinates that are measured from a single X-Y origin point with coordinates (0,0). The origin point is specified as the lower left corner of the cut file.

This practice intends to transfer a static image with no provision for editing.

This practice imposes no limits on the width or length of the cut data. Physical limitations imposed by the hardware and their effects on the output are the responsibility of the hardware manufacturer.

This practice does not support bite commands or any methods that insert multiple origin points or floating coordinate systems.

This practice does not support notch tools.

This practice does not support pattern matching.

This practice limits the cut file to contain a single block of data demarked by a compatible header and terminator. Multiple blocks of data in a single file are not allowed.