ASTM D1867 Standard Specification for Copper-Clad Thermosetting Laminates for Printed Wiring
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM G125 Standard Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants
- 13
- ASTM G125 Standard Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants
- 13.220
- ASTM G125 Standard Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants
- 13.220.40
- 19
- ASTM G125 Standard Test Method for Measuring Liquid and Solid Material Fire Limits in Gaseous Oxidants
- 19.040
- ASTM D4895 Standard Specification for Polytetrafluoroethylene (PTFE) Resin Produced From Dispersion
- ASTM D2902 Standard Specification for Fluoropolymer Resin Heat-Shrinkable Tubing for Electrical Insulation
- ASTM D3636 REV A Standard Practice for Sampling and Judging Quality of Solid Electrical Insulating Materials
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Copper-Clad Thermosetting Laminates for Printed Wiring
N D1867
Annotation
This specification covers twelve grades of thermosetting laminate with copper foil bonded to one or both surfaces. These combination forms are intended primarily for use in fabrication of printed (etched) wiring or circuit boards.
The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
Стандартная спецификация для медно-одетых затвердевающих ламинатов для печатного проводного соединения
Эта спецификация покрывает двенадцать классов затвердевающего ламината с медной фольгой, связанной к одной или обеим поверхностям. Эти формы комбинации предназначаются прежде всего для использования на производстве печатных (вытравленных) монтажных панелей или печатных плат.
