ASTM F1075 Standard Specification for Dehumidifier, Shipboard, Mechanically Refrigerated, Self-Contained
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- 23
- ASTM F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- 23.040
- ASME B31E Standard for the Seismic Design and Retrofit of Above-Ground Piping Systems
- ASME B16.21 Nonmetallic Flat Gaskets for Pipe Flanges
- ASTM F363 Standard Test Method for Corrosion Testing of Gaskets
- ASTM F112 Standard Test Method for Sealability of Enveloped Gaskets
- ASTM F336 Standard Practice for Design and Construction of Nonmetallic Enveloped Gaskets for Corrosive Service
- ASTM B280 Standard Specification for Seamless Copper Tube for Air Conditioning and Refrigeration Field Service
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Dehumidifier, Shipboard, Mechanically Refrigerated, Self-Contained
N F1075
Annotation
This specification covers self-contained dehumidifiers using hermetic refrigerant motor-compressors.
The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use
Автоматический перевод:
Стандартная спецификация для осушителя, борта судна, механически охлажденного, автономного
Эта спецификация покрывает автономные осушители с помощью герметичных охлаждающих компрессоров двигателя.
Величины, заявленные в единицах дюйма-фунта, должны рассматриваться как стандарт. Величины, данные в круглых скобках, являются математическими преобразованиями в единицы СИ, которые обеспечивают только для информации и не считают стандартными.



