ASTM D1351 Standard Specification for Thermoplastic Polyethylene Insulation for Electrical Wire and Cable
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- UL 444 UL Standard for Safety Communications Cables - Fourth Edition; Reprint with Revisions Through and Including April 30, 2015
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29.220
- 33
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 33.120
- 35
- ASTM D4565 Standard Test Methods for Physical and Environmental Performance Properties of Insulations and Jackets for Telecommunications Wire and Cable
- ASTM D2633 REV A Standard Test Methods for Thermoplastic Insulations and Jackets for Wire and Cable
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Thermoplastic Polyethylene Insulation for Electrical Wire and Cable
N D1351
Annotation
This specification covers a thermoplastic insulation which consists substantially of polyethylene.
This type of insulation is considered suitable for use on wire or cable that will be used for continuous operation at conductor temperatures up to 75 °C with a maximum conductor size of 1000 kcmil (507 mm2). The maximum voltage rating shall not exceed 35 000 V for power application or 9 000 V for series lighting.
In many instances the insulation material cannot be tested unless it has been formed around a conductor. Therefore, tests done on insulated wire or cable in this specification are solely to determine the relevant property of the insulation material and not to test the insulated conductor or completed cable.
Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
Стандартная спецификация для термопластической изоляции полиэтилена для электрического провода и кабеля
Эта спецификация покрывает термопластическую изоляцию, которая состоит существенно из полиэтилена.
