European Committee for Electrotechnical Standardization

Non electrical test methods for low voltage energy cables - Incorporates Amendment A1: 2011
 N EN 50396

Annotation

EN 50396 contains non-electrical test methods required for the testing of harmonized low voltage energy cables, especially those rated at up to and including 450/750 V.

NOTE 1 A description of the origin of these test methods and of the background to the EN are given in the Introduction and Annex A.

The particular cable standard dictates the tests which need to be performed on the relevant cable type. It also specifies whether the specific test is a type test (T), a sample test (S) or a routine test (R) for the particular cable type.

NOTE 2 T, S and R are defined in the relevant cable standard.

The requirements to be met during or after the test are specified for the particular cable type in the relevant cable standard. However, some test requirements are obvious and universal, such as the fact that no cracks shall occur during ozone test, and these are stated in the particular test method.

Test methods for use specifically in utility power cables are not covered by this EN. They can be found in HD 605.

Test methods for use specifically in communications cables are the responsibility of CENELEC TC 46X. At present such test methods are given in EN 50289 (series).

Автоматический перевод:

Не методы электрического испытания для кабелей низковольтной энергии - Включают Поправку A1: 2011