European Committee for Electrotechnical Standardization

Electrical test methods for low voltage energy cables - Incorporates Amendment A1: 2011
 N EN 50395

Annotation

EN 50395 contains electrical test methods required for the testing of harmonized low voltage energy cables, especially those rated at up to and including 450/750 V.

NOTE 1 A description of the origin of these test methods and the background to this European Standard is given in the Introduction and in Annex B.

The particular cable standard dictates the tests which need to be performed on the relevant cable type. It also specifies whether the specific test is a type test (T), a sample test (S) or a routine test (R) for the particular cable type.

NOTE 2 T, S and R are defined in the relevant cable standard.

The requirements to be met during or after the test are specified for the particular cable type in the relevant cable standard. However, some test requirements are obvious and universal, such as the fact that no breakdown shall occur during voltage tests, and these are stated in the particular test method.

Test methods for use specifically in utility power cables are not covered by this European Standard. They can be found in HD 605.

Test methods for use specifically in communications cables are the responsibility of the Technical Committee CENELEC TC 46X, Communication cables. At present such test methods are given in EN 50289 series.

Автоматический перевод: