International Organization for Standardization

Hydraulic fluid power — Single rod cylinders, 16 MPa (160 bar) compact series with bores from 250 mm to 500 mm — Accessory mounting dimensions - Second Edition
 N 13726

Annotation

This International Standard specifies the mounting dimensions required for interchangeability of accessories for 16 MPa (160 bar) compact cylinders conforming to ISO 6020-3. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO 6020-3, but this does not limit their application.

This International Standard covers the following accessories:

— AP2 - rod clevis, female thread (see Figure 1 and Table 1);

— AP4 – rod eye, plain, female thread (see Figure 2 and Table 2);

— AA4 - L – pivot pin (locking plate) (see Figure 3 and Table 3);

— AL6 – locking plate for pivot pin (see Figure 4 and Table 4);

— AA4 - S – pivot pin plain (see Figure 5 and Table 5).

These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force. The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO 2944 and ISO 3320.

Автоматический перевод:

Приводы гидравлические. Одноштоковые цилиндры малогабаритных серий, рассчитанных на давление 16 МПа (160 бар) с отверстием диаметром от 250 до 500 мм. Монтажные размеры сборочных деталей - Второй Выпуск