ASTM B428 Standard Test Method for Angle of Twist in Rectangular and Square Copper and Copper Alloy Tube
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040.15
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- ASTM B188 Standard Specification for Seamless Copper Bus Pipe and Tube
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Angle of Twist in Rectangular and Square Copper and Copper Alloy Tube
N B428
Annotation
This test method establishes the requirements for the determination of the angle of twist in rectangular and square copper and copper alloy tube.
The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартный метод испытаний для угла скручивания в прямоугольной и квадратной меди и меди сплавляет трубку
Этот метод испытаний устанавливает требования для определения угла скручивания в прямоугольной и квадратной меди, и медь сплавляют трубку.
Значения, заявленные в единицах дюйма-фунта, должны быть расценены как стандарт. Никакие другие единицы измерения не включены в этот стандарт.
