ASTM D5337 Standard Practice for Flow Rate Adjustment of Personal Sampling Pumps
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13
- ASTM D7339 Standard Test Method for Determination of Volatile Organic Compounds Emitted from Carpet using a Specific Sorbent Tube and Thermal Desorption / Gas Chromatography
- ASTM D6196 Standard Practice for Selection of Sorbents, Sampling, and Thermal Desorption Analysis Procedures for Volatile Organic Compounds in Air
- ASTM D1356 REV B Standard Terminology Relating to Sampling and Analysis of Atmospheres
- ASTM D6196 Standard Practice for Selection of Sorbents, Sampling, and Thermal Desorption Analysis Procedures for Volatile Organic Compounds in Air
- ASTM D6196 Standard Practice for Selection of Sorbents, Sampling, and Thermal Desorption Analysis Procedures for Volatile Organic Compounds in Air
- ASTM D1356 REV B Standard Terminology Relating to Sampling and Analysis of Atmospheres
- ASTM D5156 Standard Test Methods for Continuous Measurement of Ozone in Ambient, Workplace, and Indoor Atmospheres (Ultraviolet Absorption)
- ASTM D1914 Standard Practice for Conversion Units and Factors Relating to Sampling and Analysis of Atmospheres
- ASTM D5149 Standard Test Method for Ozone in the Atmosphere: Continuous Measurement by Ethylene Chemiluminescence
- ASTM D1357 Standard Practice for Planning the Sampling of the Ambient Atmosphere
- ASTM D5075 Standard Test Method for Nicotine and 3-Ethenylpyridine in Indoor Air
- Картотека зарубежных и международных стандартов
ASTM International
Standard Practice for Flow Rate Adjustment of Personal Sampling Pumps
N D5337
Annotation
This practice describes the calibration of sampling pumps commonly used for monitoring personal airborne exposures in the work-place.
This practice includes procedures for describing primary and secondary calibration techniques.
The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Утвержденный технологический процесс для корректировки расхода личных насосов выборки
Эта практика описывает калибровку отбора насосов, обычно используемых для контроля персональных перевозимых по воздуху воздействий в рабочем месте.
Эта практика включает процедуры для описания основных и вторичных методов калибровки.
Значения, утвержденные в единицах СИ, должны рассматриваться как стандарт. Никакие другие единицы измерения не включены в этот стандарт.
