JSA JIS B 1584-3 Plain bearings - Wrapped bushes - Part 3: Lubrication holes, grooves and indentations
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ISO 3548-3 Plain bearings - Thin-walled half bearings with or without flange - Part 3: Measurement of peripheral length - First Edition
- 21
- ISO 3548-3 Plain bearings - Thin-walled half bearings with or without flange - Part 3: Measurement of peripheral length - First Edition
- 21.100
- ISO 3548-3 Plain bearings - Thin-walled half bearings with or without flange - Part 3: Measurement of peripheral length - First Edition
- 21.100.10
- BSI BS ISO 3547-7 Plain bearings - Wrapped bushes - Part 7: Measurement of wall thickness of thin-walled bushes
- BSI BS ISO 3547-6 Plain bearings - Wrapped bushes - Part 6: Checking the inside diameter
- BSI BS ISO 3547-5 Plain bearings - Wrapped bushes - Part 5: Checking the outside diameter
- BSI BS ISO 3547-6 Plain bearings - Wrapped bushes - Part 6: Checking the inside diameter
- BSI BS ISO 3547-6 Plain bearings - Wrapped bushes - Part 6: Checking the inside diameter
- BSI BS ISO 3547-5 Plain bearings - Wrapped bushes - Part 5: Checking the outside diameter
- BSI BS ISO 3547-5 Plain bearings - Wrapped bushes - Part 5: Checking the outside diameter
- BSI BS ISO 3547-2 Plain bearings - Wrapped bushes - Part 2: Test data for outside and inside diameters
- ISO 12301 Plain bearings — Quality control techniques and inspection of geometrical and material quality characteristics - Second Edition
- ISO 3547-2 Plain bearings Wrapped bushes Part 2: Test data for outside and inside diameters - Second Edition
- JSA JIS B 1584-1 Plain bearings - Wrapped bushes - Part 1: Dimensions
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Plain bearings - Wrapped bushes - Part 3: Lubrication holes, grooves and indentations
N JIS B 1584-3
Annotation
This Standard specifies the shapes and dimensions of lubrication holes and lubrication grooves, and the shapes of lubrication indentations of wrapped bushes.
NOTE: The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 3547-3 : 2006 Plain bearings - Wrapped bushes - Part 3: Lubrication holes, grooves and indentations (MOD)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Простые подшипники - Обернутые кустарники - Часть 3: Смазочные отверстия, канавки и углубления
Этот Стандарт определяет формы и измерения смазочных отверстий и смазочных канавок, и формы углублений смазки обернутых кустарников.
ПРИМЕЧАНИЕ: Международный стандарт, соответствующий этому Стандарту и символу степени корреспонденции, следующие.
