CEN EN 1514-2 Flanges and their joints - Gaskets for PN-designated flanges - Part 2: Spiral wound gaskets for use with steel flanges
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN EN 1515-3 Flanges and their joints - Bolting - Part 3: Classification of bolt materials for steel flanges, class designated
- 21
- SNV SN EN 1515-3 Flanges and their joints - Bolting - Part 3: Classification of bolt materials for steel flanges, class designated
- 21.060
- SNV SN EN 1515-3 Flanges and their joints - Bolting - Part 3: Classification of bolt materials for steel flanges, class designated
- 21.060.10
- 23
- SNV SN EN 1515-3 Flanges and their joints - Bolting - Part 3: Classification of bolt materials for steel flanges, class designated
- 23.040
- SNV SN EN 13480-3 Metallic industrial piping - Part 3: Design and calculation
- CEN EN 12560-5 Flanges and Their Joints - Gaskets for Class-Designated Flanges - Part 5: Metallic Ring Joint Gaskets for Use with Steel Flanges
- BSI BS EN 13555 Flanges and their joints - Gasket parameters and test procedures relevant to the design rules for gasketed circular flange connections
- Картотека зарубежных и международных стандартов
European Committee for Standardization
Flanges and their joints - Gaskets for PN-designated flanges - Part 2: Spiral wound gaskets for use with steel flanges
N EN 1514-2
Annotation
This part of EN 1514 specifies the dimensions and marking of spiral wound gaskets for use in conjunction with flat face and raised face flanges complying with the requirements of EN 1092-1 for PN 10, PN 16, PN 25, PN 40, PN 63, PN 100 and PN 160 and up to and including DN 1 000.
NOTE 1 Dimensions of other types of gaskets for use with flanges to EN 1092-1, EN 1092-2, EN 1092-3 and EN 1092-4 are given in EN 1514-1, EN 1514-3, EN 1514-4, EN 1514-6, EN 1514-7 and EN 1514-8.
NOTE 2 Annex A lists information to be supplied by the purchaser when ordering gaskets in circumstances where the choice of the gasket materials appropriate to the service is left to the manufacturer.
Автоматический перевод:
Фланцы и их соединения - Прокладки для фланцев PN-designated - Часть 2: Спиральные прокладки раны для использования со стальными фланцами
Эта часть 1514 EN определяет измерения и маркировку спиральных прокладок раны для использования в сочетании с плоской поверхностью и повышенными фланцами поверхности, соответствующими требованиям EN 1092-1 для PN 10, PN 16, PN 25, PN 40, PN 63, PN 100 и PN 160 и до и включая DN 1 000.
