ISO 12151-2 Connections for hydraulic fluid power and general use Hose fittings Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24° cone connector ends with O-rings - First Edition
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN EN ISO 8434-1 Metallic tube connections for fluid power and general use - Part 1: 24 degree cone connectors (ISO 8434-1:2007)
- 23
- SNV SN EN 14420-1 Hose fittings with clamp units - Part 1: Requirements, types of fixing and connection, designation and testing
- ISO 8033 Rubber and plastics hoses Determination of adhesion between components - Third Edition
- ISO 8033 Rubber and plastics hoses Determination of adhesion between components - Third Edition
- BSI BS ISO 11237-2 Rubber hoses and hose assemblies Wire-braid-reinforced compact types for hydraulic applications Specification Part 2: Water-based fluid applications
- BSI BS ISO 6605 Hydraulic fluid power - Hoses and hose assemblies - Test methods
- BSI BS ISO 12151-3 Connections for hydraulic fluid power and general use - Hose fittings Part 3: Hose fittings with ISO 6162-1 or ISO 6162-2 flange ends
- ISO 6605 Hydraulic fluid power Hoses and hose assemblies Test methods - Second Edition
- Картотека зарубежных и международных стандартов
International Organization for Standardization
Connections for hydraulic fluid power and general use Hose fittings Part 2: Hose fittings with 8434-1 and 8434-4 24° cone connector ends with O-rings - First Edition
N 12151-2
Annotation
This part of ISO 12151 specifies the general and dimensional requirements for the design and performance of hose fittings with 24° cone connector ends with O-rings, in accordance with ISO 8434-1 and ISO 8434-4. These hose fittings are made of carbon steel and are intended for use with hoses with nominal inside diameters from 5 mm through 38 mm (inclusive).
NOTE 1 Materials other than carbon steel may be supplied as agreed between the manufacturer and user.
NOTE 2 For hose fittings used in hydraulic and pneumatic braking systems on road vehicles (as defined in the scope of ISO/TC 22), see ISO 4038, ISO 4039-1 and ISO 4039-2.
These hose fittings (see Figure 1 for a typical example) are for use in fluid power systems with hoses that meet the requirements of respective standards and in general applications with suitable hoses.
Автоматический перевод:
Связи для питания гидравлической жидкости и Части 2 Шланговых арматур общего использования: Шланговые арматуры с ISO 8434-1 и ISO 8434-4 конических соединителя на 24 ° заканчиваются кольцевыми уплотнителями - Первый Выпуск
