DIN EN ISO 6806 Rubber hoses and hose assemblies for use in oil burners - Specification (ISO 6806:2014)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ISO 4642-1 Rubber and plastics hoses, non-collapsible, for fire-fighting service — Part 1: Semi-rigid hoses for fixed systems - First Edition
- 13
- ISO 4642-1 Rubber and plastics hoses, non-collapsible, for fire-fighting service — Part 1: Semi-rigid hoses for fixed systems - First Edition
- 13.220
- 83
- ISO 4671 AMD 1 Rubber and plastics hoses and hose assemblies — Methods of measurement of the dimensions of hoses and the lengths of hose assemblies AMENDMENT 1: Clarification of position at which outside diameter is measured - Third Edition
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Rubber hoses and hose assemblies for use in oil burners - Specification (ISO 6806:2014)
N EN ISO 6806
Annotation
This International Standard specifies the minimum requirements for rubber hoses and hose assemblies for use in oil burners.
The following two types of hose assembly are specified.
— Type 1: Hose assemblies for flux and reflux, but not for insertion between the oil burner pump and the atomizing connection; maximum working pressure 1,0 MPa (10 bar); maximum oil temperature 100 °C.
— Type 2: Hose assemblies for insertion between the oil burner pump and the atomizing connection; working pressure 4,0 MPa (40 bar); maximum oil temperature 100 °C.
NOTE The hose assemblies specified in this International Standard are not intended to be used, without special assessment, for purposes other than oil burner installations
Автоматический перевод:
Резиновые рукава и шлангопроводы для использования в нефтяных кирпичных заводах - требование (ИЗО 6806:2014)
Этот Международный стандарт определяет минимальные требования для резиновых шлангов и шланговые соединения для использования в масляных горелках.
