0 продуктов

Авторизация

DIN EN ISO 12846 Water quality - Determination of mercury - Method using atomic absorption spectrometry (AAS) with and without enrichment (ISO 12846:2012); German version EN ISO 12846:2012

Список продуктов
Данный раздел/документ содержится в продуктах:

 

Deutsches Institut fur Normung e. V.

Water quality - Determination of mercury - Method using atomic absorption spectrometry (AAS) with and without enrichment (ISO 12846:2012); German version :2012
 N EN ISO 12846

 

Annotation

 

This International Standard specifies two methods for the determination of mercury in drinking, surface, ground, rain and waste after appropriate pre-digestion. For the first method (described in Clause 6), an enrichment step by amalgamation of the Hg on, for example, a gold/platinum absorber is used. For the method given in Clause 7, the enrichment step is omitted.

The choice of method depends on the equipment available, the matrix and the concentration range of interest. Both methods are suitable for the determination of mercury in water. The method with enrichment (see Clause 6) commonly has a practical working range from 0,01 g/I to g/I. The mean limit of quantification (LOQ) reported by the participants of the validation trial (see Annex A) was 0,008 g/I. This information on the LOQ gives the user of this International Standard an orientation and does not replace the estimation of performance data based on laboratory-specific data. It has to be considered that it is possible to achieve lower LOQs with specific instrumentation (e.g. single mercury analysers).

The method without enrichment (in Clause 7) commonly has a practical working range starting at 0,05 g/I. The LOQ reported by the participants of the validation trial (see Annex A) was 0,024 g/I. It is up to the user, based on the specific application, to decide whether higher concentration are determined by omitting the enrichment step and/or by diluting the sample(s). The sensitivity of both methods is dependent on the selected operating conditions.

Another possibility for the determination of extremely low Hg concentrations down to 0,002 g/I without pre-concentration is the application of atomic fluorescence spectrometry (see ISO 17852). Specific atomic-absorption mercury analysers allow determinations down to 0,010 g/I without pre-concentration.

Категории продуктов

 

 

 

Знакомьтесь, "Техэксперт"

 Техэксперт для iPad

 Для Android

АКЦИЯ!

Бесплатный доступ