Comitato Elettrotecnico Italiano

Fire hazard testing Part 2-12: Glowing/hot-wire based test methods - Glow-wire flammability index (GWFI) test method for materials
 N EN 60695-2-12/A1

Annotation

INTRODUCTION

Replace the fourth paragraph of the Introduction by the following:

Fires involving electrotechnical products can also be initiated from external non-electrical sources. Considerations of this nature should be dealt with in the overall fire hazard assessment.

Replace the seventh paragraph by the following:

This part of IEC 60695 describes a glow-wire flammability index test for materials. It should be used to measure, describe, and rank the properties of materials in response to heat caused by contact with an electrically heated wire under controlled laboratory conditions. This may be useful for the evaluation of materials for use in products that may be exposed to excess thermal stress such as a fault current flowing through a wire, overloading of components, and/or bad connections. It should not be used to solely describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire hazard assessment which takes into account all of the factors which are pertinent to a particular end use.

Автоматический перевод:

Часть 2-12 тестирования пожарной опасности: Glowing/hot-wire базировал методы испытаний - метод испытаний Проводного жаром индекса воспламеняемости (GWFI) для материалов